HOOD PROTECTOR INSTALLATION INSTRUCTIONS

KIT CONTENTS

Plastic clip (With metal nut inside) / Screw / Plastic washer / Double sided tape / Plastic wedge / Plastic screw cap

PRODUCT INSTALLATION

  1. Screw two plastic clips into the holes in the center of the product by using the plastic washer
  2. Open the hood of your vehicle
  3. Center the product on the hood
  4. Place the two clips on the hood by pushing
  5. Screw the other clips into the hood at the level of the edge holes
  6. Screw the other clips into the hood at the level of the edge holes
  7. Open a surface of the double-sided tape and stick together with the wide side of the rubber mounts
  8. Adhere the plastic wedges between the hood and the product at the appropriate points so that the tape surface adheres to the bottom of the product and prevents the product from flexing
  9. Remove the protective cover on the product
  10. Install the plastic screw caps on the screws

PRECAUTIONS

  • Be sure that the hood is clean and dry
  • Do not over tighten the screws
  • When opening / closing the hood, do NOT pull / push on Hood Protector
  • Use mild detergent and water solution for washing (Do NOT use solvents)
  • Avoid the use of automatic "Brush Style" car washes

TO REMOVE

Reverse the above procedure